WorkCentre Pro Hole Punch Options

WorkCentre Pro models equipped with a hole punch mechanism create either two, three, or four holes depending on the kind of hole punch mechanism installed. Hole-punching is available with the Advanced Office Finisher and the Professional Finisher. The number of holes created by the punch cannot be changed through your printer drivers.

The following table illustrates the relative location of the punch holes in relation to page orientation and number of page images printed on a single page (N-up Printing):

 

Hole Punching
x represents the approximate location for two-hole punching

Orientation

Feed Orientation*

Driver Type/Selection

N-Up Printing

LEF

  • PostScript - Portrait

  • PCL - Portrait

1, 4, 9, 16

LEF

  • PostScript - Portrait

  • PCL - Portrait

 

2, 6

LEF

  • PostScript - Landscape

  • PCL - Landscape

 

1, 4, 9, 16

LEF

  • PostScript - Landscape

  • PCL - Landscape

 

2, 6

SEF

  • PostScript - Portrait

  • PCL - Portrait

 

1, 4, 9, 16

1, 4, 6, 9, 16

SEF

  • PostScript - Portrait

  • PCL - Portrait

 

2, 6

2

SEF

  • PostScript - Landscape

  • PCL - Landscape

 

1, 4, 9, 16

1, 4, 6, 9, 16

SEF

  • PostScript - Landscape

  • PCL - Landscape

 

2, 6

2

*Feed Orientation - LEF:  Long Edge Feed; SEF: Short Edge Feed